Recente artikelen
-
ALLES OVER // Holbein Acryla Gouache + video ALL ABOUT // the Holbein Acryla Gouache April 10, 2020
-
Wat is er zo bijzonder aan Palomino Blackwing potloden? What makes the Palomino Blackwing pencils so special? April 08, 2020
-
Winsor & Newton Professional vs Cotman, wat zijn de verschillen? Winsor & Newton Professional vs Cotman, what are the differences? April 05, 2020
Tag cloud
DIY KERST // Maak je eigen kerstballen (Deel 2) DIY CHRISTMAS // Make your own baubles (Part 2)
Hi all,
Ik had de smaak te pakken bij het maken van de vorige kerstballen dat ik op het idee kwam voor deel 2.
Heb je deel 1 al gezien?
DIY Materialen:
- Houten kralen 20 mm
- Houten kralen 35 mm
- Houten kralen 40 mm
- Coliro palette
- Kwastje
- Schaar
- Katoen koord +/- 1 meter
- evt afplaktape
- Een ijzerdraadje of grote naald om de kralen makkelijk te rijgen
DIY Tutorial
Stap 1: Beschilder je houten kralen. Als je het Coliro palette gebruikt, zorg er dan voor dat je weinig water bij de inkt gebruikt. Bij teveel water gaat de inkt 'bloeden' en krijg je geen strakke lijnen. Ik heb afplakband geprobeerd maar ik kreeg strakkere lijnen met de hand.
Stap 2: Knip 3x 30cm katoenkoord.
Stap 3: Maak vast een knoop bij de uiteinden
Stap 4: Gebruik een ijzerdraadje of naald en rijg de kralen op het touw.
Stap 5: Je kan nu de hoogte bepalen, je kan bijvoorbeeld de knoop nog iets hoger maken.
Hi all,
I got a taste of making the baubles in the previous vlog, I even got an idea for part 2.
Have you seen part 1 yet?
DIY Materials:
- Wooden beads 20 mm
- Wooden beads 35 mm
- Wooden beads 40 mm
- Coliro palette
- Brush
- Scissors
- Cotton cord +/- 1 meter
- possibly masking tape
- An iron wire or large needle to easily thread the beads
DIY Tutorial
Step 1: Paint your wooden beads. If you use the Coliro palette, make sure you don't use a lot of water with the ink. With too much water, the ink will 'bleed' and you won't get clean lines. I tried masking tape but got tighter lines by hand.
Step 2: Cut 3x 30cm cotton cord.
Step 3: Tie a knot at the ends
Step 4: Use an iron wire or needle and thread the beads on the rope.
Step 5: You can now determine the height, for example you can make the knot a little higher.